![]() ![]() **Installing SmartRF Flash Programmer** **Prerequisites for Linux and Mac Users**: Use the Uniflash tool. If you don't have administrator privileges, enter a user ID and password with these privileges to continue. For users with administrator privileges, click "Yes" to proceed. **Important Note**: The installation of SmartRF Flash Programmer must be executed with administrator privileges to allow USB driver installation. **Installation Instructions**: 1. Run the setup file and follow the on-screen instructions. 2. Read the manifest file for information about the release. 3. Download the ZIP file to your hard drive. **System Requirements**: SmartRF Flash Programmer and SmartRF Flash Programmer 2 run on both 32-bit and 64-bit versions of Microsoft Windows 7 and Windows 10. **Features**: * Read/Write MAC (IEEE EUI64/48/BLE) addresses * Verify software image on device against file * Read out software image from device into binary, hex, or ELF files (ELF and BIN for ARM devices only) * Append software image to existing software on device * Programming/update firmware and bootloader on Evaluation Boards' USB MCU * Programming of SW images on low-power RF wireless MCUs
0 Comments
Leave a Reply. |